The long purple LED light will stop flashing and turn solid purple. Press and release one of the buttons on the remote control.Your garage door opener is now in programming or learning mode. When you release the programming button, the long purple LED light will start flashing next to the circular LED.Press and hold the program button for at least 3 seconds or until the blue round LED lights up.Set up your ladder to access the learn button on the powerhead.Press the remote button, and if the light under the powerhead blinks red, it’s compatible but not programmed to the opener. If you just replaced your remote control, you must confirm it is compatible with your Genie garage door opener.Press the previously active remote button the garage door should not operate.You have now deactivated your remote control. To reset your Genie garage door opener, push the programming button until the round LED light stops blinking.

Resetting will disconnect all synced transmitters and clear all programmed settings.

When reprogramming your garage door opener, it’s best to start with a blank slate.

For older models between 1995-2010, the programming button is labeled “Learn Code” or “Radio Signal,” while those for 2011 and later usually say “Program/Set.” Both buttons function similarly but have slightly different lighting sequences for each action.

Thus, you’ll have to remove the cover to access the programming button and indicator light. If your garage door opener has no antenna, it has an external receiver.The programming button is a large square button at the back of the motor head with two LED indicators next to it.Some models have three buttons on the control panel. You may find this button near the antenna, but the location can vary depending on the model. Find the programming button on your Genie garage door opener.Locate the learn button on the motor head Here’s how to reprogram a Genie three-button remote control. If you have a different Genie opener model, follow the reprogramming instructions in the owner’s manual. These openers have a large square programming button on the bottom of the opener, next to the up and down buttons. The following instructions are for the following Genie garage door opener models: Genie makes a variety of remote controls compatible with the two types of garage door openers they also make. Reprogramming the remote control to your Genie garage door opener Also, neighbors can accidentally operate your garage door opener if they use a remote with the same fixed code.

Since the number of fixed codes is limited, this makes it easy for hackers to breach your garage door opener. This means that the remote controls convey the same fixed security code every time you press the remote button. Therefore, it eliminates the possibility of hacking and prevents unauthorized entry.īut if your garage door opener is from before 1996, it uses a fixed code system. It helps keep your garage door opener safe from hackers and unsuspecting neighbors using their garage door opener remotes to control your opener.Įvery time you activate your Genie garage door opener, the Intellicode system picks a new code from billions of possible combinations.

Intellicode Access Security System is Genie’s rolling code technology. We have provided you with a detailed guide on reprogramming your Genie garage door opener to your remote control, keypad, and car to maintain your home’s security. However, the procedure and light indicators will vary slightly depending on the opener model. Reprogramming your genie garage door opener involves clearing all programmed settings and syncing the opener again to the keypad or remote controls. This could be the original Genie device or a universal replacement. Genie Garage Door Openers are popular for their convenience, ease of installation, and multi-brand compatibility. However, you’ll need to reprogram your Genie garage door opener if the remote control or keypad stops working or after replacing either device.

Lost pin genie intellicode keypad